I'll take a look at the Waters homepage to see if there's anything that's incrementally useful compared to their online manual as far as installing and calibrating a seal pack goes. Separation Science offers free learning from the experts covering methods, applications, webinars, eSeminars, videos, tutorials for users of liquid chromatography, gas chromatography, mass spectrometry, sample preparation and related analytical techniques. The calibration was going pretty well until another message showed up, "could not find upper seal". If the plunger has to be moved to much without pressure build up, the observed message is likely. Bull76 wrote: Hi, You need to make small adjustments to the sensor assy. Carry out a compression check and if that passes, carry out an injection accuracy test or lift test. I've moved the platform down to the point where it says that the "top sensor is too high", then moved it up perhaps by too many notches where it now says something along the lines of seal width is too low.
© 2020 serpentnstars.com - All rights reserved. All Models are over 21 y.o.